Kostenlose Rückgabegarantie
Using the Ti240 Thermal Camera for Building & Home Inspections
Building and home inspections are critical for identifying hidden issues that impact energy efficiency, safety, and structural integrity. From missing insulation and air leaks to moisture intrusion and electrical hotspots, many problems are invisible to the naked eye — until you use a thermal camera for building inspection. The HANMATEK Ti240, a compact handheld thermal camera with 240×240 IR resolution, makes these inspections faster, more accurate, and non-invasive, helping homeowners, inspectors, and contractors save time and money.
Thermal imaging reveals temperature differences (Delta T) caused by defects, with optimal results during 10–20°C indoor-outdoor differences — like winter audits after running heat for 4 hours (per ASTM E1186 standards). The Ti240's high resolution captures subtle gradients that lower-res cameras blur.
Common Building & Home Issues Detected with the Ti240
- Missing or Poor Insulation Cold spots on walls, attics, or floors indicate gaps, settling, or compression. The Ti240's 57,600 pixels pinpoint exact locations for targeted fixes, preventing up to 50% energy loss from poor envelopes.
- Air Leaks & Drafts Scan windows, doors, weatherstripping, chimneys, and vents. Thermal patterns show infiltration around poorly sealed frames or outlets — common culprits in 80% of homes. Pair with a blower door for airtightness verification.
- Moisture & Water Damage Wet materials have higher thermal mass, appearing cooler. Detect leaks in roofs, walls, pipes, or basements before mold or rot sets in. The Ti240's ≤60 mK sensitivity spots subtle dampness.
- HVAC & Radiant Heating Issues Uneven floor temps reveal radiant malfunctions; cold ducts signal blockages or leaks. Inspect coils, filters, and compressors for efficiency losses.
- Roof & Exterior Problems Flat roofs show ponding water; scan for compromised shingles or flashing from afar.
- Electrical in Panels/Walls Hot breakers or wiring behind drywall — early fire prevention.
Real thermal examples from inspections (like attic insulation gaps or window leaks) demonstrate how 240×240 clarity outperforms spot IR tools.
Why the HANMATEK Ti240 Excels in Building Inspections
- 240×240 Resolution — Sharp detail for small defects (4× more pixels than 120×90).
- -20°C to 550°C Range — Covers cold leaks to hot spots; ±2°C accuracy.
- 25 Hz Refresh + 6 Palettes — Real-time scanning with Iron Red/Rainbow for contrast.
- 9-Hour Battery & IP54 — Full-day audits; 1.5m drop-proof.
- Alarms, Fusion, Storage — High/low alerts, visible overlay, 8GB SD + PC software for reports.
Inspectors use it pre-purchase (add to contracts), post-renovation verification, or energy audits — documenting with pro images for claims/insurance.
Elevate your building inspections today: Buy HANMATEK Ti240 Thermal Camera
More new tools: New Arrival HANMATEK Tools
See problems before they cost thousands — with the Ti240.
Einen Kommentar hinterlassen